hi pkd,
So you're saying this only happens sometimes and it is not predictable
when it may or may not work?
Instead of "kill -9 <pid>" use "kill <pid>" where <pid> is replaced by
the process id number. The default is usually -15 (Terminate)
regards,
Glenn
On 2021-05-31 15:59, 박기당 wrote:
> hi, Glenn.
>
> How do I terminate to clean up without killi -9?
> It compiles dhcp-4.2.6 and operates on embedded target systems.
> dhcrelay is being restarted when the address of the interface
> associated with dhcrelay is added or deleted.
> And I've never seen such an error before, and it's not reproduced
> afterwards, so I don't know if it's meaningful to apply strace.
> I always kill dhcrelay and run it again two seconds later.
>
> regards,
>
> pkd.
> _______________________________________________
> ISC funds the development of this software with paid support
> subscriptions. Contact us at
https://www.isc.org/contact/ for more
> information.
>
> dhcp-users mailing list
>
[hidden email]
>
https://lists.isc.org/mailman/listinfo/dhcp-users_______________________________________________
ISC funds the development of this software with paid support subscriptions. Contact us at
https://www.isc.org/contact/ for more information.
dhcp-users mailing list
[hidden email]
https://lists.isc.org/mailman/listinfo/dhcp-users
Locked
